Owner's Manual

128-9323
7 of 8
Page 7
YouwillnotetheLEDashingvetimes,pause,andthenashtwotimes,pause.Thispattern
will be repeated three times indicating the new code (52) has been accepted and stored in
memory.
NOTE: Ifafterstep7,theLEDashesacodeotherthanwhatwasjustentered,thisindicates
that the code has not been changed. You will have to repeat steps 1 through 7 above
being certain to note the following:
Acceptable digits 10ths or units are 1 through 9. The unit will not recognize a 0 (Zero),
or no digit entered in any place, units or tenths.
NOTE: If 15 seconds of inactivity expire, or if the ignition switch is turned off for more then 5
seconds during any of the above steps, the unit will revert back to the last successfully
stored code.
ADDITIONAL REMOTE FUNCTION :
This system allows the control of any one of the following optional accessories;
Remote Car Starter
Remote Window Closure
Remote Window Open
To operate the optional accessory;
1. Press the lock, then unlock, then lock buttons on your keychain transmitter within 3 sec-
onds.
2. The optional accessory will immediately activate.
OPTIONAL AUTO LOCK/UNLOCK FEATURE :
If your existing factory installed keyless entry system did not include the automatic door lock
and unlock feature, then this feature can be activated from this upgrade module. When this
accessory has been added, any time the ignition key is turned to the on position and all vehicle
doors are closed, the doors will lock in 4 seconds. Additionally, any time the ignition key is
turned to the off position, the doors will unlock.
ELIMINATING THE ARM / DISARM CHIRPS :
Thenormalarminganddisarmingconrmationchirpscaneasilybeturnedoffusingthevalet
pushbutton switch. To do this;
1. Turn the ignition key on, and then off.
2. Within 10 seconds of turning the ignition key off, press and release the valet switch 3 times.
3. a. If, before proceeding with step 1, the chirps were on, then you will hear 2 chirps to
indicate that the chirps have been turned off.
b. If, before proceeding with step 1, the chirps were off, then you will hear 1 chirp to
indicate that the chirps have been turned on.
4. Whenever power to the system has been disconnected ( for repair or service to the
vehicle), the chirps will be activated when the power is re - connected. To turn the chirps
off, simply execute steps 1 through 3 above.
NOTE : Whenever the Arm/Disarm chirps are bypassed, the 3 chirp defective zone and
the 4 chirp intrusion indicator will always operate. This feature will always warn
you if a door was left ajar when arming, or the vehicle was tampered with in
your absence.