Owner's Manual

128-9323
6 of 8
Page 6
Programming Your Custom Override Code:
Unlike override switches easily found, and defeated, this system allows the consumer to
program a personal override code, offering a higher level of security. The system comes
from the factory with a pre-programmed override code of 11. To change this default override
code, do the following:
1. Disarm the system by use of the transmitter, or by use of the emergency override sequence.
Turn the ignition switch to the on position.
2. Within 10 seconds, press and release the valet/override switch, 3 times.
3. Within 10 seconds turn the ignition switch off, on, off, on, off, on. (The siren or horn will
beepandthelightswillashonetime.)
4. Within 10 seconds, begin to enter your chosen 10ths digit by pressing and releasing the
pushbutton switch from 1 up to 9 times.
5. Within 10 seconds of the last entered 10ths digit, turn the ignition switch off then on.
6. Within 10 seconds, begin to enter your chosen units digit by pressing and releasing the
pushbutton switch from 1 up to 9 times.
7. Finish by turning the ignition switch to the off position.
Ifthenewcodewasaccepted,theunitwillreportbackthenewlyenteredcode,byashing
theLED,rstindicatingthe10thsdigit,pauseandthentheunitsdigit.Theunitwillreport
the new code three times with a one second pause between each code, then the system
willbeginarming.IftheLEDashpatternreportsthepreviouslystoredcode,thenewcode
was not entered correctly. Please repeat steps 1 through 7 above considering the following.
NOTE: Acceptable digits 10ths or units are 1 through 9. The unit will not recognize a 0 (Zero),
or no digit entered in any place, units or tenths.
NOTE: If 15 seconds of inactivity expire, or if the ignition switch is turned off for more then 5
seconds during any of the above steps, the unit will revert back to the last successfully stored
code.
Custom Code Programming Example:
To Change the code from the factory pre-assigned code of 11 to “52” you would do the
following:
1. Disarm the system by use of the transmitter, or by use of the emergency override sequence.
2. Turn the ignition switch to the on position.
3. Within 10 seconds, press and release the valet/override switch, 3 times.
4. Within 10 seconds turn the ignition switch off, on, off, on, off, on. (The siren or horn will
beepandthelightswillashonetime.)
5. Within 10 seconds, begin to press and release the push button switch to set the tenths
digit.
(As per the example, press and release 5 times to set the tenths digit to 5)
6. Within 10 seconds of the last press of the pushbutton, turn the ignition switch off then on.
7. Within 10 seconds, begin to press and release the push button switch to set the units
digit.
(As per the example, press and release 2 times to set the units digit to 2).
 8. Turntheignitionswitchtotheoffposition.ImmediatelyobservetheLEDashpattern.