Installation Manual

128-9318
5 of 16
Page 5
14 Pin Main Wiring Connector P/N 1124303
WIRING THE SYSTEM
6 Pin Power Connector: P/N 1124297
Red/White (5 Amp) & Red Fused (15 Amp) Wires : +12 VDC Constant Battery Source
This wire supplies power to the alarm's control module as well as the input to the parking light relay.
Connect this input to a constant on +12 Volt supply.
Orange Wire: 300 mA Ground Output When Armed
This wire is provided to control the starter cut relay. Connect the Orange Wire to terminal #86 of the
relay. Connect relay terminal #85 to an ignition wire in the vehicle that is live when the key is in the on
and crank positions and off when the key is in the off position. (This is where the Yellow Wire from the
alarm should be connected).
Cut the low current starter solenoid wire in the vehicle, and connect one side of the cut wire to relay
terminal #87A. Connect the other side of the cut wire to relay terminal #30.
NOTE: This is a normally closed starter cut arrangement and when power is removed from the security
system, the starter disable feature will not operate, allowing the vehicle to start. Audiovox does
not recommend using the Orange Wire to interrupt anything but the starting circuit of the vehicle.
Black Wire: Chassis Ground
Connect this wire to a solid, metal part of the vehicle’s chassis. Do not confuse this wire with the thin
black antenna wire that exits the control module independently.
White w/ Black Trace Wire: Positive Output to Siren
Route this wire through a rubber grommet in the rewall, and to the siren location.
Connect the White / Black Wire to the positive wire of the siren. Secure the black ground wire of the siren
to chassis ground.
Red Wire: + 12 Volts Module Supply
See the Red/White Wire above.
White Wire: + 12 VDC Pulsed Parking Light Output (15 Amp Max)
This wire is provided to ash the vehicle’s parking lights. Connect the White Wire to the positive side of
one of the vehicle’s parking lights.
1 Black w/ White Trace Wire: 300 mA Horn Output
The Black w/ White Trace Wire is provided to beep the vehicle’s horn. This is a transistorized low current
output, and should only be connected to the low current ground output from the vehicle’s horn switch.
If the vehicle uses a +12 VDC horn switch, then connect the Black w/ White Trace Wire to terminal #86
of the AS 9256 relay ( or an equivalent 30 Amp automotive relay ), and connect relay terminal #85 to
a fused +12 VDC battery source. Connect relay terminal #87 to the vehicle’s horn switch output, and
connect relay terminal #30 to a fused +12 VDC battery source.