Installation manual

11
Mounting the Mute/On-Off Button
The PSD100 system has an optional mute/on-off switch. When installed with
a rear system, the button will mute the rear PSD system until the ignition is
turned off and back on. When installed on a front sensor system, the button
serves as an on/off switch for front detection. To install the Mute/On-Off
button:
1. Determine a suitable place to mount the button.
2. Route the wires for the button to the area where you will install
the control module. Make sure they will not be pinched by the
panel or moving parts.
3. Check the area behind the button location to ensure it is clear of
obstacles. Drill a 10mm diameter hole for the button,
4. Mount the button and secure with the supplied locking ring.
5. Attach the cable connecting the button to the module.
Control Module Dip Switch Settings
The PSD100 has a number of settings. You can modify these settings at any
time.
SETTING SWITCH 1 SWITCH 2 SWITCH 3 SWITCH 4
UP Rear Bumper 4 Sensor Full
Detection
(7ft)
High
Sensitivity
(general use)
DOWN Front Bumper 2 Sensor Normal
Detection
(5ft)
Low
Sensitivity
(use if required
to remove
ground
detection)