Installation manual

13
Setting the Learning System (Rear Sensors)
If an object mounted on the vehicle is causing the Rear sensor system to false
alarm (tow bar, rear mounted tire, bicycle rack etc.) you can ‘train’ the PSD
system to ignore these obstacles.
1. Place the vehicle in an area at least 15ft away from obstacles.
2. Start the engine and leave it running.
3. Place the vehicle in and out of reverse gear 4 times at 1-2 second
intervals, ending with the vehicle in reverse.
When the vehicle enters learning mode, the LED display will display
RED-ORANGE-GREEN alternately for 10 seconds silently. The system
will then beep for 1 second to confirm that the ‘training’ was successful.
4. Once ‘trained’, whenever the vehicle is placed in reverse the LED
will flash orange and then green and the system will beep once to
alert the driver that part of the detection area is being ignored.
The learning system can be re-trained at any time by performing the
training cycle explained above.
The system can be reset to default by removing the vehicle mounted
obstacle and performing the training cycle.
Once the learning system has been reset, when placed in reverse, the
system will only flash green once (showing that there is no area in the
detection zone being ignored).