Installation Manual

ManualsBrandsAudiovox ManualsMobile MultimediaAudiovox VM9216BT

VM9216BT

VM9216BT Head Unit

External Microphone

Power / Speaker Harness

NAV104 / Microphone Harness

Hardware Bag

Single DIN Sleeve

Trim Ring

Owner’s Manual

Installation Guide

Tools and Supplies

You will need these tools and supplies to install your VM9216BT:

• Torx type, at-head and Philips screwdrivers

• Wire cutters and strippers

• Tools to remove existing radio (screwdriver, socket wrench set or other tools)

• Electrical tape

• Crimping tool

• Volt meter/test light

• Crimp connections

• 18 gauge wire for power connections

• 16 – 18 gauge speaker wire

What’s in the Box

WARNING! Never install this unit where operation and viewing could interfere

with safe driving conditions.

Installation Guide

Summary of content (4 pages)

PAGE 1
Installation Guide VM9216BT What’s in the Box VM9216BT Head Unit External Microphone Power / Speaker Harness NAV104 / Microphone Harness Hardware Bag Single DIN Sleeve Trim Ring Owner’s Manual Installation Guide Tools and Supplies You will need these tools and supplies to install your VM9216BT: • Torx type, flat-head and Philips screwdrivers • Wire cutters and strippers • Tools to remove existing radio (screwdriver, socket wrench set or other tools) • Electrical tape • Crimping tool • Volt meter/
PAGE 2
VM9216BT Disconnecting the Battery To prevent a short circuit, be sure to turn off the ignition and remove the negative (-) battery cable prior to installation. NOTE: If the VM9216BT is to be installed in a car equipped with an on-board drive or navigation computer, do not disconnect the battery cable. If the cable is disconnected, the computer memory may be lost. Under these conditions, use extra caution during installation to avoid causing a short circuit. Pre-installation 1.
PAGE 3
VM9216BT Wiring WARNING! Only connect the unit to a 12-volt power supply with proper grounding. Complete wiring as illustrated in the wiring diagram on page 4. Once the wiring is complete, reconnect the battery negative terminal. If there is no ACC available, connect the ACC lead to the power supply with a switch. NOTE: When replacing a fuse, be sure to use correct type and amperage to avoid damaging the radio.
PAGE 4
VM9216BT Wiring Diagram IMPORTANT: Incorrect wiring connections can damage the unit. Follow the wiring instructions carefully, or have the installation handled by an experienced technician. For basic iPod® connectivity, you can use the white 30-pin to USB iPod® cable that came with your Apple device. For iPod® video or photo playback, you must purchase the jLink-USB cable. Connect the iPod® cable to the rear chassis iPod® inputs (USB / 3.