User's Guide

NOTE: If this is the first time using the Xpress XM receiver, the screen

will alternately display the preview channel screen and a number of

messages, including: “Activate Your XM 1-800-XM RADIO”. If not, go to

channel 1 using the Rotary/Select Knob on the Xpress XM receiver or

the CH Up/Down buttons on the remote control.

Basic Operation

With the Xpress XM receiver properly installed, activated and connected

to your home/vehicle audio system or boom box, proceed as follows:

Turning Xpress ON and OFF

Set up your Audiovox Xpress XM receiver using the installation

instructions included in this Kit (Home Kit, or Boom Box Kit), or with the

help of a professional installer.

NOTE: Refer to Antenna Aiming during the installation procedure.

Press the Power button to turn the unit ON. When the unit turns ON the

XM logo will appear for 3-seconds (curved lines on either side of the XM

logo gradually appear) (see Figure 4) followed by the Audiovox logo.

These screens will be followed by the active channel

(see Figure 5), which defaults to the last tuned channel setting prior to

power being turned OFF. When the unit is shut OFF the XM logo will

appear and the curved lines on either side of the XM logo gradually

disappear.

Getting Started