Manual

OWNER’S MANUAL
AV 5.1k /
8
1. Protection fuse: 100 A;
2. Power (Ground): Terminal block for the amplifier power supply negative pole connection. Insert here the battery
negative cable or wire connected to the vehicle chassis. The plug accepts cables up to 2 A.W.G. For better
current transfer it is recommended to use cables with the maximum cross-section possible and in any case of the
same cross-section of the cable connected to the positive pole;
3. Power (11-15 VDC): Terminal block for the amplifier 11÷15V DC power supply positive pole connection. Insert
here the battery positive cable. The plug accepts cables up to 2 A.W.G. For better current transfer it is
recommended to use cables with the maximum cross-section possible and in any case of the same cross-
section of the cable connected to the negative pole;
4. +CAP: Terminal for connecting the positive pole of an external super capacitor;
5. +/- Left A Speaker Out;
6. +/- Right A Speaker Out;
7. +/- Left B Speaker Out;
8. +/- Right B Speaker Out;
9. +/- SUB OUT Speaker;
10. Remote Sub Control: inputs for remote control of the VCRA Sub volume control (optional);
11. Remote IN/OUT:
REMOTE IN: terminal for the remote cable coming from the device which turns on the amplifier.
REMOTE OUT: terminal to launch the remote voltage to turn on other amplifier. The output voltage is 12V 50 mA.
On this terminal the start-up control will be available for other devices even if Rem In is not in use and SPK INs
(see 6.4) are in use for starting-up.
6. REAR PANEL
6.1 HOW TO CONNECT POWER CABLES
AV 5.1k
BL AL AR BR C(SUB)
BATT GND CAP
SUB VOL.
CONTROL
REMOTE
OUT IN
1
4
9
10
11
6
5
3
2
8
7
6
AV 5.1k
BL AL AR BR C(SUB)
BATT GND CAP
SUB VOL.
CONTROL
L: min 16 mm (5/8”)
L: max 26 mm (1”)
Ø MAX: 2 AWG
Ground
Super
Capacitor
not provided
Fuse
Holder
not provided
Ground
Battery
REMOTE
OUT IN