User's Manual

FCC:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference. (2) This device must accept any
interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
WARNING: Changes or modications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance 20cm between the radiator
& your body.
FCC:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference. (2) This device must accept any
interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
WARNING: Changes or modications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance 20cm between the radiator
& your body.
FCC:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference. (2) This device must accept any
interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
WARNING: Changes or modications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance 20cm between the radiator
& your body.
FCC:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference. (2) This device must accept any
interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
WARNING: Changes or modications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance 20cm between the radiator
& your body.
IC:
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject
to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts
de licence. L’exploitation est autorisée aux deux conditions suivantes:
(1) l’appareil ne doit pas produire de brouillage, et
(2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement.
RF Exposure
This device has been evaluated and shown compliant with the RF exposure requirements listed in
RSS-102 - Radio Frequency (RF) Exposure Compliance of Radio communication Apparatus limits
under xed exposure conditions (antennas are greater than 20cm from a person’s body) when
installed in certain specic OEM congurations.
Cet appareil a été évalué et montré conforme aux exigences d’exposition RF énumérées dans RSS-
102 - Exposition aux fréquences radio (RF) Conformité des limites des appareils de communication
radio dans des conditions d’exposition xes (les antennes sont à plus de 20 cm du corps d’une
personne) lorsqu’elles sont installées dans certains congurations OEM spéciques.
IC:
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject
to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts
de licence. L’exploitation est autorisée aux deux conditions suivantes:
(1) l’appareil ne doit pas produire de brouillage, et
(2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement.
RF Exposure
This device has been evaluated and shown compliant with the RF exposure requirements listed in
RSS-102 - Radio Frequency (RF) Exposure Compliance of Radio communication Apparatus limits
under xed exposure conditions (antennas are greater than 20cm from a person’s body) when
installed in certain specic OEM congurations.
Cet appareil a été évalué et montré conforme aux exigences d’exposition RF énumérées dans RSS-
102 - Exposition aux fréquences radio (RF) Conformité des limites des appareils de communication
radio dans des conditions d’exposition xes (les antennes sont à plus de 20 cm du corps d’une
personne) lorsqu’elles sont installées dans certains congurations OEM spéciques.
IC:
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject
to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts
de licence. L’exploitation est autorisée aux deux conditions suivantes:
(1) l’appareil ne doit pas produire de brouillage, et
(2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement.
RF Exposure
This device has been evaluated and shown compliant with the RF exposure requirements listed in
RSS-102 - Radio Frequency (RF) Exposure Compliance of Radio communication Apparatus limits
under xed exposure conditions (antennas are greater than 20cm from a person’s body) when
installed in certain specic OEM congurations.
Cet appareil a été évalué et montré conforme aux exigences d’exposition RF énumérées dans RSS-
102 - Exposition aux fréquences radio (RF) Conformité des limites des appareils de communication
radio dans des conditions d’exposition xes (les antennes sont à plus de 20 cm du corps d’une
personne) lorsqu’elles sont installées dans certains congurations OEM spéciques.
IC:
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject
to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts
de licence. L’exploitation est autorisée aux deux conditions suivantes:
(1) l’appareil ne doit pas produire de brouillage, et
(2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement.
RF Exposure
This device has been evaluated and shown compliant with the RF exposure requirements listed in
RSS-102 - Radio Frequency (RF) Exposure Compliance of Radio communication Apparatus limits
under xed exposure conditions (antennas are greater than 20cm from a person’s body) when
installed in certain specic OEM congurations.
Cet appareil a été évalué et montré conforme aux exigences d’exposition RF énumérées dans RSS-
102 - Exposition aux fréquences radio (RF) Conformité des limites des appareils de communication
radio dans des conditions d’exposition xes (les antennes sont à plus de 20 cm du corps d’une
personne) lorsqu’elles sont installées dans certains congurations OEM spéciques.
CE:
EU Regulatory Conformance
We, Elettromedia s.r.l., hereby declare that this device
is in compliance with the essential requirements and
other relevant provisions of Directive 2014/53/EU.
Technical Specications:
Operating temperature: 0 ÷ 55 °C
Frequency range: 2402-2480MHz
Max. RF Output Power: < 10dBm
Hardware version: R01
Software version: R1.0
CE:
EU Regulatory Conformance
We, Elettromedia s.r.l., hereby declare that this device
is in compliance with the essential requirements and
other relevant provisions of Directive 2014/53/EU.
Technical Specications:
Operating temperature: 0 ÷ 55 °C
Frequency range: 2402-2480MHz
Max. RF Output Power: < 10dBm
Hardware version: R01
Software version: R1.0
CE:
EU Regulatory Conformance
We, Elettromedia s.r.l., hereby declare that this device
is in compliance with the essential requirements and
other relevant provisions of Directive 2014/53/EU.
Technical Specications:
Operating temperature: 0 ÷ 55 °C
Frequency range: 2402-2480MHz
Max. RF Output Power: < 10dBm
Hardware version: R01
Software version: R1.0
CE:
EU Regulatory Conformance
We, Elettromedia s.r.l., hereby declare that this device
is in compliance with the essential requirements and
other relevant provisions of Directive 2014/53/EU.
Technical Specications:
Operating temperature: 0 ÷ 55 °C
Frequency range: 2402-2480MHz
Max. RF Output Power: < 10dBm
Hardware version: R01
Software version: R1.0
RF Exposure:
This equipment complies with radiation
exposure limits set forth for an uncontrolled
environment.
Note: This product can be used in EU countries
without any restrictions.
Manufacturer information:
Company name: ELETTROMEDIA
Address: 62018 Potenza Picena (MC) Italy
Strada Regina km 3,500
Tel: T [phone]
Web: www.elettromedia.it
RF Exposure:
This equipment complies with radiation
exposure limits set forth for an uncontrolled
environment.
Note: This product can be used in EU countries
without any restrictions.
Manufacturer information:
Company name: ELETTROMEDIA
Address: 62018 Potenza Picena (MC) Italy
Strada Regina km 3,500
Tel: T [phone]
Web: www.elettromedia.it
RF Exposure:
This equipment complies with radiation
exposure limits set forth for an uncontrolled
environment.
Note: This product can be used in EU countries
without any restrictions.
Manufacturer information:
Company name: ELETTROMEDIA
Address: 62018 Potenza Picena (MC) Italy
Strada Regina km 3,500
Tel: T [phone]
Web: www.elettromedia.it
RF Exposure:
This equipment complies with radiation
exposure limits set forth for an uncontrolled
environment.
Note: This product can be used in EU countries
without any restrictions.
Manufacturer information:
Company name: ELETTROMEDIA
Address: 62018 Potenza Picena (MC) Italy
Strada Regina km 3,500
Tel: T [phone]
Web: www.elettromedia.it