Installation guide

ADVANCED MANUAL / bit Ten D /
16
2. De-equalization analysis: setting the bit Ten D.
 •PushtheDE-EQSETbuttonandchecktheDE-EQCHECKLEDfollowingtheinstructionsinthefollowingimage.
 •TheDE-EQLEDturnsontoshowthatyourecordedade-equalizationcurve,otherwiseitwillbeoff.
 •IftheDE-EQCHECKLEDonthebit Ten D is on, you can run the de-equalization procedure again.
The new data will erase the ones previously stored.
*Important: Confirmorabortthede-equalizationprocesswithin5minutes,otherwisethebitTenDwillautomatically
reset and turn off.
DE-EQ CHECK LED
OUT OF DE-EQ PROCESS
DE-EQ IN PROGRESS
ABORT DE-EQ PROCESS
NO NEED DE-EQ
: ANALYZING
MEMORY CANCEL
LED OFF
LED ONDE-EQ OK
NO DE-EQ
NEED DE-EQ
END
DE-EQ SET
0,5 sec
5 sec
5 sec
1 sec
LED OFF
END
DE-EQ CHECK LED
OUT OF DE-EQ PROCESS
DE-EQ IN PROGRESS
ABORT DE-EQ PROCESS
NO NEED DE-EQ
: ANALYZING
MEMORY CANCEL
LED OFF
LED ONDE-EQ OK
NO DE-EQ
NEED DE-EQ
END
DE-EQ SET
0,5 sec
5 sec
5 sec
1 sec
LED OFF
END
* *
6