Users Manual

10
USER'S MANUAL
5. CONNECTIONS
REMOTE TURN ON
1. Through the DRC MP main control switch (to turn on). Keep the DRC MP main control knob pressed (to shut
down). In this case no other Remote In connections are required, but they can coexist
(see section 5.1).
2. By connecting the REMOTE IN terminal with a Remote Out signal coming from an after-market audio source.
3. Through the SPEAKER IN CH1-CH2. The AUTO TURN ON (ART) is activated by connecting the amplied
head unit output to the SPEAKER IN CH1-CH2 input channel. This function can be enabled/disabled using
the bit One HD Virtuoso PC software
(see section 7.2.2.2).
The bit One HD Virtuoso is on when the Audison logo lights up in blue.
After receiving the turn on input the bit One HD Virtuoso takes 6 seconds to start working. It can be turned on / off
in the following ways:
WARNING: to power the bit One HD Virtuoso,
use 1 mm
2
(16 AWG) min. cables
POWER SUPPLY
5.1 POWER SUPPLY AND REMOTE TURN ON
5.2 HOW TO TURN THE bit One HD Virtuoso ON/OFF
5.3 PERSONAL COMPUTER and DIGITAL REMOTE CONTROL (DRC MP)
FUSE HOLDER
Not provided
suggested fuse
2A delayed
Ground
Battery
12V
Ground
DRC IN
DRC / AC Link cable (4,5 m / 177.16”)
USB cable
(powered)
USB INPUT
DRC/ACLink cable (provied)
HOW TO CONNECT THE DRC MP
Remote in
Remote in
Remote out
Remote out
AMPLIFIERS
WARNING: if you chose
to turn on the ampliers
equipped with the AV
bit In module using the "AC
LINK Turn On" function, do
not connect the remote wires
coming from the bit One HD
Virtuoso. If you decide to turn
on the ampliers equipped
with AV bit In modules with
the remote wires coming from the bit One HD Virtuoso, place the
"AC LINK Turn On" switch in the "OFF" position. The two ignition
systems cannot coexist.
5