Users Manual

12
USER'S MANUAL
5.5.1. SPEAKER IN Hi-level MULTICHANNEL (max 12 CHANNELS)
MASTER SPEAKER IN input selection
1. Through the DRC MP, selecting the MASTER input.
2. Through the MASTER input, using the bit One HD Virtuoso PC software.
*
CH1-CH2: Auto Turn On System (ART) (see section 7.2.2)
WARNING: the digital inputs accept up to 192 kHz / 24 bit stereo PCM signals. So DOLBY DIGITAL (AC3)
multi-channel signals coming from audio/video sources (such as the audio of a lm in DVD) or DTS can
not be reproduced. The output of these devices will therefore be set in STEREO mode for the signal to be
reproduced.
*
Remark: when performing the installation of ber optic cables, the minimum bending radius should be 40 mm.
A bending with higher radius value may cause the cable to break and the consequent disruption of the digital signal.
OPTICAL 1/OPTICAL 2 inputs selection
1. Through the DRC MP, selecting the OPTICAL 1 / OPTICAL 2 input.
2. Through the OPTICAL 1 SEL / OPTICAL 2 SEL terminal properly set up (see section 4.3.4).
This control is activated by connecting the terminal at + 12V.
3. Through the selection of the OPTICAL 1/ OPTICAL 2 input via the bit One HD Virtuoso PC software.
4. Through the selection of the OPTICAL 1/ OPTICAL 2 input on the OEM source, using the “Auto Input Switch”
function, via the bit One HD Virtuoso PC software
(see section 5.6.1 - 7.2.4).
AUX
S/PDIF
0.1V 2.0V
OPTICAL OUT
ON
+
-
Rem
+ R
ANALOG OUT
Not Supplied
Not Supplied
S/PDIF OUT
75 Ohm Coax Cable
COAX S/PDIF
24 bit 192 kHz max
OPTICAL S/PDIF
24 bit 192 kHz max
*
*
5.5 HIGH-LEVEL INPUT SIGNALS
bit One HD Virtuoso
Bottom Side
SDCDRCC
OEM
AMPLIFIER
OEM HEAD UNIT
MAX 12
CHANNELS
INPUT
*
5.6 OPTICAL 1/OPTICAL 2 DIGITAL INPUT SIGNALS
C
2
O
S/PDIF Interface
bit DMI
MOST Interface
5