Users Manual

13
USER'S MANUAL
5.6.1. “AUTO INPUT SWITCH” OPTICAL 1 / OPTICAL 2 SIGNALS.
Activate the ”AUTO INPUT SWITCH” function on the OPTICAL 1 or OPTICAL 2 input via PC software to enable the
bit One HD Virtuoso OPTICAL 1 or OPTICAL 2 input, each time the source AUX input is activated. When using this
function the bit One HD Virtuoso volume can be controlled through the source volume (see section 7.2.4 - 8.3.5).
Connect the bit One HD Virtuoso OPTICAL 1 or OPTICAL 2 input to the audio source and the processor’s RVA input
to the Master source AUX input (Head Unit).
WARNING: the “Auto Input Switch” function activation, and the subsequent selection of the auxiliary input to be used,
may cause the loss of the other two auxiliary inputs not selected.
Remark: when activating the “Auto Input Switch” function, the DRC/PC Software can no longer be used for
the switch of the audio system inputs.
The switch can be enabled through the audio system source, selecting the AUX or Master input.
When the “AIS - Auto Input Switch” function is active and a bit Play HD is connected to the system along with
Full DA ampliers (AD LINK - AC LINK) the DRC MP will be disabled and will display the following: “DRC DISABLED”.
C
2
O
S/PDIF Interface
C
2
O
S/PDIF Interface
C
2
O
S/PDIF Interface
SD
AUX
S/PDIF
0.1V 2.0V
OPTICAL OUT
ON
+
-
Rem
+ R
ANALOG OUT
Not Supplied
Not Supplied
S/PDIF OUT
75 Ohm Coax Cable
COAX S/PDIF
24 bit 192 kHz max
OPTICAL S/PDIF
24 bit 192 kHz max
HEAD
UNIT
TOSLINK
Connector
bit One HD Virtuoso
Front panel
bit One HD Virtuoso Rear panel
SD
AUX
S/PDIF
0.1V 2.0V
OPTICAL OUT
ON
+
-
Rem
+ R
ANALOG OUT
Not Supplied
Not Supplied
S/PDIF OUT
75 Ohm Coax Cable
COAX S/PDIF
24 bit 192 kHz max
OPTICAL S/PDIF
24 bit 192 kHz max
HEAD
UNIT
AUX IN
TO AUX IN HEAD UNIT
TOSLINK
Connector
bit One HD Virtuoso
Front panel
bit One HD Virtuoso Rear panel
Left
Right
SUB
SUB
REAR
REAR
FRONT
FRONT
CENTER
CENTER
HI LEVELS
OUTPUT
HI LEVELS
OUTPUT
Connect the Head
Unit AUX input to the
RVA connector of the
bit One HD Virtuoso
as follows, using the
wiring supplied in the
giftbox.
The selection of the
source AUX input
will then allow the
automatic selection
of the bit One HD
Virtuoso auxiliary
input.
If the car HEAD UNIT
does not feature an
AUX analog input,
connect a USB
memory (or SD
Card) to the USB
reader of your audio
source as shown to
the side. The USB/
SD device must
contain the .mp3
format le in the RVA
TONE folder located
inside the Setup
CD (these les can
also be downloaded
from the Audison
website). Please
note that the storage
device must contain
only this le and no
other les. If you use
the USB memory
to activate the
switching via the RVA function, just select the USB (SD) input of the main source (Head Unit).
*
USB Storage / SD Card
*
5