Users Manual

19
USER'S MANUAL
7. bit One HD Virtuoso SETUP WITH PC
To adjust the bit One HD Virtuoso functions a software is required. The processor needs to be connected to the PC
and turned on. After installing the software, start it by selecting the icon shown on your desktop.
The rst window is the startup page where one of the following modes needs to be selected:
- CONNECT WIRED USB, connects the bit One HD Virtuoso to the PC via USB;
- CONNECT WIRELESS WI-FI, it allows the connection via W-CON module connected to the bit One HD
Virtuoso in wireless mode with the PC;
- OFF LINE MODE IIR FILTERS, demo mode with active FIR Filters;
- OFF LINE MODE IIR FILTERS, demo mode with active IIR Filters;
- RESCUE, bit One HD Virtuoso connected for update/maintenance
(see section 9.4).
In this case even if the bit One HD Virtuoso
processor is connected to the PC, it does
not interact with the software.
The OFFLINE mode can be used to work
on the software to get familiar with the
processor multiple functions without
connecting the bit One HD Virtuoso to the
PC and it is possible to select two operating
modes: IIR and FOR. For more information
on the specic functions
(see section 7.2)
(CONNECT mode).
The software is pre-set to start with a
3-way Front active Stereo + 2-way Rear
active Stereo + Sub + 2-way active central
channel.
To set a new “virtual” system, and so to
change the inputs and select the outputs,
the function I/O Conguration Wizard in
the “Cong” window of the software main
menu needs to be selected. Follow the
same instructions as per CONNECT mode
(see section 7.2).
Here is how the bit One HD Virtuoso IIR software appears when started in OFFLINE mode.
Here is how the bit One HD Virtuoso FIR software appears when started in OFFLINE mode.
7.1 OFFLINE MODE IIR/FIR
7