Users Manual
Table Of Contents
- Index
- 1. PRODUCT DESCRIPTION
- 2. PACKAGING CONTENTS
- 3. bit One HD Virtuoso AND DRC MP INSTALLATION
- 4. CONNECTION PANELS - DESCRIPTION
- 5. CONNECTIONS
- 6. bit One HD Virtuoso SOFTWARE AND DRIVERS - INSTALLATION GUIDE
- 7. bit One HD Virtuoso SETUP WITH PC
- 8. bit One HD Virtuoso SETUP USING A PC
- 9. TROUBLESHOOTING
- 10. TECHNICAL SPECIFICATIONS
- 11. ADDENDUM
22
USER'S MANUAL
PC software turn on in CONNECT MODE:
Upon turn on, if correctly interfaced with the
PC (software and drivers installed correctly),
the device will show the communication
window as shown in the gures to the side.
In the default conguration, the bit One HD Virtuoso is congured as shown below:
Input Hi Level Master:
- CH1 Front Left Full
- CH2 Front Right Full
- CH3 Rear Left Full
- CH4 Rear Right Full
AUTO TURN ON Hi Level: enabled
Output Analog (Pre Out):
- CH1: Front Left Woofer - CH2: Front Right Woofer
- CH3: Front Left Midrange - CH4: Front Right Midrange
- CH5: Front Left Tweeter - CH6: Front Right Tweeter
- CH7: Rear Left Woofer - CH8: Rear Right Woofer.
- CH9: Rear Left Tweeter - CH10: Rear Right Tweeter
- CH11: Center Tweeter - CH12: Center Woofer
- CH13: Subwoofer
If at the end of the scanning the bit One HD Virtuoso is not found:
- check that the bit One HD Virtuoso is switched on (Audison logo light on)
;
- check that the USB cable is connected correctly;
- press OK to search for the device again;
- press CANCEL to start the OFFLINE mode.
7