Users Manual
Table Of Contents
- Index
- 1. PRODUCT DESCRIPTION
- 2. PACKAGING CONTENTS
- 3. bit One HD Virtuoso AND DRC MP INSTALLATION
- 4. CONNECTION PANELS - DESCRIPTION
- 5. CONNECTIONS
- 6. bit One HD Virtuoso SOFTWARE AND DRIVERS - INSTALLATION GUIDE
- 7. bit One HD Virtuoso SETUP WITH PC
- 8. bit One HD Virtuoso SETUP USING A PC
- 9. TROUBLESHOOTING
- 10. TECHNICAL SPECIFICATIONS
- 11. ADDENDUM
27
USER'S MANUAL
A progress bar and specic messages
show the procedure’s implementation.
Once the procedure is completed,
the window will show the message
“Press Next to Continue”.
4. Input level automatic calibration
- Press BACK to go back to the
previous step.
- Press NEXT to continue with the
conguration.
- Press CANCEL to exit.
ERROR MESSAGE MAY APPEAR
“Input Level too low”
Should a message informing the user
that the input signal is too low “Input too
low” appear when the inputs calibration
is completed, proceed as follows:
- Press BACK to go back to the previous
step, check the inputs connection to
the bit One HD Virtuoso and repeat the
calibration procedure
- Press NEXT to continue with the
conguration, check the inputs
connection. And then proceed with
the manual sensitivity calibration
(see section 8.11)
.
- Press CANCEL to exit.
Once the procedure is
completed the window
will show the sensitivity levels
setup according to the source
interfaced with the bit One HD
Virtuoso.
This window is active and
a further manual sensitivity
adjustment can be performed.
Select:
- Ref: 0dB Reference setup
referring to the use of music
tracks recorded at 0dB
- +3dB - +6dB: referring to the
Use of music tracks recorded at a
level lower than 0dB (-3dB ÷ -6dB)
- Press BACK to go back to the previous step.
- Press NEXT to continue with the conguration.
- Press CANCEL to exit.
7