Users Manual

32
USER'S MANUAL
Speakers can be selected just by clicking
on them. If the left tweeter, left midrange
or left woofer are selected, the software
provides the ability to automatically
activate also the right tweeter, right
midrange or right woofer. Once the
software is started, this choice will affect
the dedicated crossover type
E.g.: if on the rear system only the
woofers are activated, the software will
only show a low-pass or band-pass
lter as available. If you want to use
a coaxial system as rear channel, both
tweeter and woofer need to be selected
and then you need to specify that a
passive crossover is connecting them,
so the software will show a high-pass
lter as available.
- Press BACK to go back to the previous step.
- Press NEXT to go ahead with the conguration.
- Press CANCEL to exit.
Remark: if you decided to use the FIR mode the bit One HD Virtuoso will avail of a maximum of 9 output
channels to be enabled.
Remark: Audio systems with at least 4-way front or 3 Rear are not fully compatible with AV bit In and
bit Tune.
9. Selection of the speakers available in the system
From this point onwards a simulation of a system with the following components will be used:
- 3-way Front active
- 2-way Rear active8
- 2-way center passive
- Stereo Sub;
All 13 output channels of the bit One HD
Virtuoso in IIR mode will be used.
7