Users Manual

35
USER'S MANUAL
The selection of I/O conguration using the
"PASS THROUGH" allows the interface in direct
conguration between inputs and outputs.
Moreover, during the guided procedure it
allows to divide the emission front in order
to increase the number of existing ways per
front. The peculiarity of this conguration
is that it does not provide any equalization,
correction of time delays, phase variations
and channel sums, allowing subsequently
only to intervene on time and phase alignment
equalization for the Master input. When using
the other auxiliary inputs (AUX, Optical 1/2) it
is also possible to separate the Master setup
by creating one that performs better than the
limits set by the OEM system.
Remark: if the Master conguration features
Rear Surround channels, during the selection of the auxiliary inputs these will not be available. The
procedure must be performed by selecting which memory to assign the Master Pass-Through
input from the start.
1. Inputs selection
- The type of input available for Pass-Through
mode is High level. This type of approach
has the function of being able to maintain all
the audio features of the OEM system.
7.2.3 PASS THROUGH
- Press BACK to go back to the previous step.
- Press NEXT to continue with the conguration.
- Press CANCEL to exit.
The inputs can be selected by clicking on
the system’s loudspeakers assigning the
corresponding channel number. Based on
the analog input type there will be 12 input
channels to be manually customized.
In Pass-Through mode it will be possible to
interface with 5.1/7.1 factory systems without
losing any functions of the dolby digital
systems.
- Press BACK to go back to the previous step.
- Press NEXT to continue with the conguration.
- Press CANCEL to exit.
2. Analog inputs conguration
7