Users Manual
Table Of Contents
- Index
- 1. PRODUCT DESCRIPTION
- 2. PACKAGING CONTENTS
- 3. bit One HD Virtuoso AND DRC MP INSTALLATION
- 4. CONNECTION PANELS - DESCRIPTION
- 5. CONNECTIONS
- 6. bit One HD Virtuoso SOFTWARE AND DRIVERS - INSTALLATION GUIDE
- 7. bit One HD Virtuoso SETUP WITH PC
- 8. bit One HD Virtuoso SETUP USING A PC
- 9. TROUBLESHOOTING
- 10. TECHNICAL SPECIFICATIONS
- 11. ADDENDUM
40
USER'S MANUAL
Speakers can be selected just by clicking
on them. The software assumes that
if you select left tweeters, midrange
or woofers, the right ones will also be
activated automatically. This choice will
affect, once the software is started, the
type of dedicated virtual crossover.
Remark: if you selected the FIR mode the
bit One HD Virtuoso will have a
maximum of 9 out channels to enable.
Pass through 1:1
IIn this conguration the number of output channels is equal to the number of input channels. So
if you have 8 channels in input it will be possible to have a system with 8 channels in output. The
Software, however, will make other speakers available to increase the ways
(see following point).
Extended PASS THROUGH
In this conguration compared to the previous one it was decided to extend the number of output
channels with respect to the same input conguration. In fact we would have 3 channels Front Out
stereo compared to 2 channels Front Input stereo, and 2 channels Rear out Stereo compared to a
Real Full stereo system.
- Press BACK to go back to the previous step.
- Press NEXT to continue with the conguration.
- Press CANCEL to exit.
At the end of the setup
8. Selection of the speakers available in the system
7