Users Manual

43
USER'S MANUAL
If you choose to activate the Optical 1 input as the Master input of your source, and this does not have an output
volume control, this operation is essential to be able to adjust the volume from your audio source. For connections,
refer to
section 5.4.3 - 5.6.1 of this manual and proceed as follows.
7.2.4 MASTER INPUT OPTICAL 1
1. Auto Input Switch
The automatic volume control for the
auxiliary source (Aux - Optical 1/2) can be
activated through the Head Unit volume
control, if it is provided with an AUX input
(see section 5.4.3, 5.6.1; 8.3.5 ). If the car HEAD
UNIT does not have an AUX analog input,
connect a USB memory (or SD Card) to
the USB reader of your audio source as
shown to the side. The USB/SD device
must contain the mp3 format le available
in the RVA TONE folder located inside
the Setup CD (these les can also be
downloaded from the Audison website).
Please note that the storage device must
only contain this le and no other les. If
you use the USB memory to activate the switching via the RVA function, simply select the USB (SD)
or Master input.
- Press BACK to go back to the previous step.
- Press NEXT continue with the calibration.
- Press SKIP to bypass the procedure.
Follow the instructions listed below:
- connect the AUX IN inputs of the
source (Head Unit) to the bit One HD
Virtuoso RVA input.
- select the source AUX IN input
(Head Unit).
- set the source volume to the
maximum undistorted level.
At the end of the procedure:
- Press BACK to go back to the
previous step.
- Press NEXT to continue with
the conguration.
- Press CANCEL to exit.
7