Users Manual

54
USER'S MANUAL
The bit One HD Virtuoso manages the system setup working
on Preset A by default; however, it also offers the possibility to
store and recall eight Presets (A, B, C, D,E,F,G,H).
Pressing the MEMORY button on the main menu you can access
the different functions you can perform on the featured presets.
The following functions are available:
- Load All Presets: it loads all the memories (A/B/C/D/E/F/G/H)
from a le previously saved (.prs format);
- Save All Presets: it saves all the memories (A/B/C/D/E/F/G/H)
in a le that can be recalled (.prs format);
- Load Current Preset: it loads a memory previously saved
(.pro format) by placing it on the memory you are operating on;
- Save Current Preset: it saves the memory you are operating
on in a le that can be recalled (.pro format);
- Copy Preset From: it provides the ability to copy the content
of one memory into another memory;
- Current Preset Default: it restores the crossover and
equalization default values, that would be suggested at the
end of the set up procedure;
- Enable Memory Overall: it enables the Overall function
which recalls a memory previously saved (see following point),
optimized for a perfect listening from all positions within the
car compartment. This function can be activated through the
terminal, setting the Overall Sel cable to +12V
(see section 8.3.4);
- Select Memory Overall: it congures an existing memory as
“Overall”. If an existing memory has been congured with time
delays, these will be reset and the Car Central will be set up as
the listening position
(see section 4.3.5). At a later stage, the
settings related to this “Overall” memory can be modied.
The following data will be stored into the presets:
- the lter settings for each channel;
- the time delay settings for each channel;
- the equalization settings for each output channel;
- the Main EQ settings
(see section 8.9.2);
- the Dynamic EQ settings/activation (see section 8.12.3);
- the Bass Boost settings/activation (see section 8.12.4);
- the output levels of each channel;
- listening points markers.
We recommend that you copy the parameters entered in the
preset you are using into the presets that are not being used.
The presets can be recalled through the DRC MP. If some
presets are not stored, they will store the default settings.
Pass through
In Pass through mode there is only one memory, assigned in
the "I / O conguration Wizard" phase, to the Master input.
So when the Master input is selected will be available only one
memory, and it will not be possible to copy other memories
on it. The remaining memories and related functions will be
available at the input change.
3
8.4 MEMORY
8