Users Manual

63
USER'S MANUAL
- From Farthest Speaker cm/inch: the related distance between the loudspeakers and the farthest speaker in the system.
- From Farthest Speaker ms: the delay introduced between the farthest speaker and the rest of the system.
If a ne set is entered, the value on the channel map will become red.
- The software, in addition to offering the conversion of values according to the selected mode, will allow their
adjustment, passing from one mode to another.
WARNING: if, once you have set the distances according to the “driver” listening point you click on the “passenger”
listening point, the bit One HD will not re-calculate the delays according to the new reference point because
the buttons available in the SELECT A CHANNEL diagram are merely descriptive and their only purpose is to
remind you that you have set the delays for that listening point!
8.7.2.3 TIME DELAY SETTING PASS-THROUGH MODE.
In the case of the Pass-Through mode with selection of the Master input, it is also possible to manage time delays.
It must be specied that if the bit One HD is interfaced to a source with time delays, it is advisable to intervene by
acting only on the Fine Set.
Once the time alignment procedure has been completed, it will be possible to intervene on the output equalizer
(MASTER), to optimize the response of the system according to the level alignment at the various frequencies.
For the auxiliary inputs Optical 1/2 and Aux instead it is possible to act on the time delays setup, as described in the
previous paragraphs, since these inputs are not connected to the Master input.
The bit One HD Virtuoso software provides a series of Parametric / Paragrac
equalizers to be managed on screen which, with extreme versatility, provide for an
optimal calibration of the audio system. The user can operate on the equalization
of the Master or AUX analog inputs by choosing the “Input EQ” option, on the
single output channels equalization by selecting the “Channels EQ” option and
operate on the whole system equalization by choosing the “Main EQ” option.
Thanks to the active Pop Up menu it is possible to intervene in a more precise and
accurate way on all the available intervention points, working full-screen on the
equalizers using all the control commands.
8
8.8 EQ SETTINGS
8