Users Manual

73
USER'S MANUAL
•
FIR POLES: it is possible to set the FIR
parametric pole by operating on the setup
window adjusting the
Frequency (f: 100Hz÷20KHz step min 1HZ),
Gain (g: -15 dB ÷ +15dB step min 0.1 dB)
and the Q factor (Q: 0.1÷ 16 step min 0.1)
using the cursors.
The POP UP menu allows a 360 ° use of the main functions
through the functions that can be activated via the Channel Map.
1) MUTE: Mute Enabled; Mute disabled.
2) SOLO: Solo Enabled; Solo disabled.
3) FASE: Phase not inverted; Phase inverted.
4) Multi Sel: it allows the activation of multiple channels on the
Channel Map in order to display the total electrical response on
Channels EQ.
5) Volume: it manages the overall system volume.
6) Volume Sub: it manages the overall SUB level volume.
During the equalizer calibration, the display shows the changes that
are made to the electrical signal that is sent to the speakers via the
ampliers in real time.
The actual audio signal reproduced by the system depends on the type
of speakers used and their positioning. To analyse the acoustic
response, use a spectrum analyser connected to a microphone.
Otherwise you need to make use of your experiencein listening and
rene the calibration by relying on it.
The poles can be edited manually using the mouse pointer.
To change the "Q" factor, you will just need to act on the
mouse wheel equipped with this function.
- The keys and : allow the selection of the pole to
be adjusted on the diagram. The successful selection
of the pole is displayed by a circle around it.
- Key : allows the selection of the “F”, ”G” and “Q”
poles control point. The successful selection of the control
point is visible through the green color of the control slider.
- Keys + and + .
1. Flat / Reset: it restores, if enabled, all the poles of the
parametric equalizer in the default position.
2. Link L/R: it applies, when active, the equalization curve
to both the right and left channels simultaneously.
3. L->R R->L: this function is active when "Link L / R" is
deactivated. By clicking on one of the two keys it is
possible to transfer the equalization curve of the Left channel to the
Right one and vice versa.
8