Owner`s manual

23
OWNER’S MANUAL
AV due /
9.2 FRONT PANEL
1. AD Link: Digital audio bus that can transmit the signal of 8 channels. It exploits a Class 5 or 6 shielded cable for
Ethernet networks normally used in computer networks.
AD Link IN: RJ-45 input terminal to connect a digital signal coming from other AV amplifiers or
other external devices equipped with AD Link (bit One / bit Ten D).
AD Link OUT: RJ-45 terminal output for connection to external devices capable of receiving the AD Link
digital signal (AV / TH amplifiers).
2. AC Link: It is composed of a digital bus and control signals for the management of the functions of the device to
which it is connected. It provides the ability to build a digital network interacting with other devices provided
with AC Link such as AV / TH amplifiers and digital audio processors. The RJ-12 terminated cable is a
6-pin cable, like the one normally used for digital telephone purposes, but it is not compatible with digital
telephone technology.
AC Link IN: RJ-12 input terminal for connection to the processor or other devices located upstream of the system
(see 9.4).
AC Link OUT: RJ-12 input terminal for connection to the processor or other devices located downstream of the
system (see 9.4).
The AC Link connection is able to provide power to the external device.
AC Link-Remote IN: If an amplifier provided with AV bit IN is connected to bit Ten D processor, the amplifier can be
turned on via the processor, without the use of the amplifier Remote-In.
If another processor is used (bit One) or if there is a Thesis TH amplifier in the AC Link chain, the Remote-In
function on the AC Link won’t be available.
If in the AC Link chain there is an amplifier different from the AVs (Thesis TH), the Remote-In function on the
AC Link has to be disabled. Set the AV bit IN AC Link Turn ON jumper to OFF as shown in the image below.
MENU DOWN UP ENTER
AV bit IN
ON OFF
U2
JMP1
ACLINK TURN ON
WARNING: for AC Link / AD Link connections, only use the cables supplied with the products.
Important: adjust the amplifier volumes to position 1 (5V RMS) when using the AV bit IN module.
1 2
AV bit IN
AD Link
IN OUT
AC Link
IN OUT
9