User manual

9
GETTING STARTED
Installation using THE "SET-UP WIZARD"
Place Audisse Shokunin on a at surface and plug the AC power plug into the AC mains
power socket, be sure the voltage is correct.
IMPORTANT: In order to disconnect the Audisse Shokunin from the AC mains power
completely, the AC power plug should be removed from the AC mains power socket
completely and it shall remain readily operable and should not be obstructed during
intended use.
When you apply power, the display on the sound system will light up and say: 'Audisse
Shokunin'.
After a few seconds the radio will then enter Standby and the clock will display '00:00' as
shown.
To continue to setup Audisse Shokunin press the
Power button
. If this is the rst time
that you use Audisse Shokunin (or after a Factory Reset) the display will show 'Setup
wizard' and 'YES' will be highlighted on the screen.