User manual

To nd more FM stations press the

Tuning/Seek/Select control

to repeat the scan

operation. To scan down in frequency, rotate the

Tuning/Seek/Select control

in a anti-

clockwise direction rst and then press the control. Your radio will scan down the FM

band from the currently displayed frequency and will stop scanning when it nds a signal

of sufcient strength.

When the end of the waveband is reached Audisse Shokunin will recommence tuning

from the opposite end of the waveband.

Use the

Volume control

to adjust the sound level as needed.

PRESETTING RADIOSTATIONS

There are 40 memorypresets. They are used in the same way for each operating mode.

The Audisse Shokunin has the unique function of Preset + and Preset –

This enables you to quickly zap through your whole preset list.

When performing a Factory Reset the whole Preset memory of the radio will be emptied.

To store radio stations into 40 memory presets by using

Preset button

Press the

Power button

to switch on Audisse Shokunin.

Tune to the required radio station as previously described.

To store the station as a preset station, press and hold the

Preset button

until the

display shows a preset menu 'Save to Preset'.

Rotate the

Tuning/Seek/Select control

to the desired preset number until it is

highlighted. Press the

Tuning/Seek/Select control

to conrm and the display shows

‘Preset Stored’. The station will be stored under the chosen preset button. Repeat this

procedure as needed for the remaining presets.

Stations which are already stored in the presets may be over written by following the

above procedure.

Note: The radio station presets are retained in memory when the sound system is

switched off and disconnected from the mains supply.