User's Manual

Hint: All microphones are available individually as well as with complete systems.

CONNECTOR

The bodypack uses a mini 3-pin XLR connector for all microphones. Other brands of

microphones can be used with the Audix Performance Series Wireless system; however, it

will be necessary to rewire the microphone connector to a mini 3-pin XLR (f). In this case,

note the following pin conﬁguration:

PERFORMANCE TIPS

The best position for a wireless receiver is within line of sight whenever possible.

For more complex set ups, consider extending the antenna range by using the

ANTDA4161 active antennas.

High quality batteries will provide the best results for handheld and bodypack

transmitters. Rechargeable batteries typically have a shorter usage span. It is not possible

to use two sets of transmitters simultaneously on the same frequency. It will not work.

Each time a scan and sync is performed, the transmitter will always be tuned to the

current frequency on the receiver. When using dual systems, always scan and sync each

channel independently from one another.

SETTING UP MULTIPLE SYSTEMS

It is fairly straightforward to get 16 channels of wireless to work simultaneously within

one frequency band (32 megs). This is done using a standard Scan and Sync method. The

systems will stay in the same Group until the group maxes out its channel selection. At this

point, it may be necessary to manually select a diﬀerent Group for additional

pre-coordinated channels.

Pin 3: Signal

Pin 2: Bias (voltage)

Pin 1: Shield