Installation Guide

ManualsBrandsAudix ManualsHanging MicrophonesTri-Element Hanging Ceiling Microphone with Hard Mount

PROFESSIONAL MICROPHONES

AUDIX M3

INSTALLATION GUIDE

Thank you for choosing Audix! Our products are designed to provide you with many years of

reliable service. Please read this manual before using the system

for optimal installation and operation.

Summary of content (4 pages)

PAGE 1
PROFESSIONAL MICROPHONES AUDIX M3 INSTALLATION GUIDE Thank you for choosing Audix! Our products are designed to provide you with many years of reliable service. Please read this manual before using the system for optimal installation and operation.
PAGE 2
IN THE PACKAGE 1 2 3 4 5 1 M3 Tri-element Hanging Ceiling Microphone 2 JBM3 - Plenum rated junction box circuitry 3 Junction box lid 4 Breakout cable consisting of RJ45 female to three terminal block connectors 5 Seismic / Fire restraint cable OPTIONAL ACCESSORIES 6 PLENHSEM3 Brass plenum bell housing (patent pending). This brass housing is specifically designed to provide a plenum seal when threaded on to the plenum junction box.
PAGE 3
INSTALLATION AND WIRING INSTRUCTIONS Fig A. Remove ceiling tile and drill 5/8” (16mm) hole in the desired location. Fig B. Position the JBM3 plenum rated junction box 2 over the drilled hole. Fig C. Remove the nut from the threaded portion of the M3 cable 1 , feed cable through the tile hole and into the junction box. Fig D. Install the threaded nut with shoulder side down and secure. Fig E. Insert the 7 pin mini female XLR connector into the male receptacle. Fig F.
PAGE 4
M3 TRI-ELEMENT OPERATING PROCEDURE The M3 contains three independent microphones and audio channels for interfacing into the mixing device or audio console. The Audix provided breakout cable 4 is designed to interface with a professional DSP controller using terminal blocks. Audix has an optional breakout cable 7 that terminates with three XLR connectors. The M3 microphone requires phantom power voltage of 18-52 volts.