Technical data

COMfortel 1400 - Firmware Version 1.4 - COMfortel Set V3.6 - Operation and Configuration V01 04/2014 157
Functions
Do-not-disturb
Configuring Type of Do-not-disturb
Defining the type of Do-not-disturb function determines how do-not-disturb works when it is
enabled.
The configuration can be made as follows:
• Using COMfortel Set
• Using the telephone
Using COMfortel Set to Configure the Type of Do-not-disturb
1. Open the page Settings/functions > Do-not-disturb.
2. Under Kind of do-not-disturb, select one of the following options:
Note:
Parallel to the kind of do-not-disturb, All (PBX), the call deblocker (incoming)
can be enabled so that the VIP numbers registered in the call deblocker on
the PBX are not rejected.
Internal telephone calls are only rejected if the kind of do-not-disturb
function All (PBX) and All (telephone) are used. An internal subscriber can
reach a protected telephone in an emergency with a priority call if the kind
of do-not-disturb function All (PBX) is used. Calls are only registered in the
caller list on the telephone if the kind of do-not-disturb function All
(telephone) is used.
Further steps:
– Save your configuration before closing.
All (PBX): The do-not-disturb function is carried out via the PBX. All incoming
calls are rejected and not entered in the caller list on the telephone.
Reject anonymous: All anonymous calls are rejected.
Only contacts: All calls are rejected except for calls from contacts listed in the
telephone book.
All (telephone): The do-not-disturb function is carried out via the telephone. All
incoming calls are rejected and entered in the caller list on the telephone.