Technical data

COMfortel 1400 - Firmware Version 1.4 - COMfortel Set V3.6 - Operation and Configuration V01 04/2014 237

Functions

Macro

Configuring and Operating Function Key for Macro

Press the key while the telephone is in the idle state to execute a macro. If the H command

(hang-up/pick-up with the hook key) is located at the beginning of a macro, the macro saved in

the system is executed immediately. If this is not the case, you need to first confirm the start of

macro execution.

In addition and depending on the settings, when a macro is defined on the first key level, the

status of the macro in question is indicated by the corresponding LED.

Note: If there is a macro on both levels of a function key, LED control is also

performed by the macro on the second level. This makes it possible, for

instance, to use the macro to switch the LED on the one key level and to use

the macro to switch LED off on the other key level. This allows the switching

status of a simultaneously switched function to be read on the LED.

The configuration can be carried out as follows:

• Using COMfortel Set

• Using the telephone

Using COMfortel Set to Configure the Function Key for Macro

1. Open the page Function keys > Assign function keys.

2. Click one of the following tabs:

3. Right-click the function key you want to assign.

A function selection dialogue opens.

4. Select the Macro function.

The current settings for defining the key are displayed.

5. In the Macro sign entry field, enter the macro. Possible entries:

LED signalling on the key:

Depending on the purpose of the commands Lo, Lg, Lr and Ly.

Level 1: Keys are defined on the first key level.

Level 2: Keys are defined on the second key level.