Technical data

COMfortel 1400 - Firmware Version 1.4 - COMfortel Set V3.6 - Operation and Configuration V01 04/2014 261
Functions
Call Forwarding
Configuring and Operating Function Key for Call Forwarding for Subscribers
Note: If you press the Telephone book key before entering the destination
number, you can select the desired phone number from the telephone book.
4. Enter the destination number. Possible entries:
Important: Enter telephone numbers exactly as when dialling, for example,
external telephone numbers always with a leading exchange line access
number. (exception: direct exchange access). The default exchange line
access number on the PBX is "0" in the factory settings; however, this can be
changed for several PBXs (see instructions for the PBX).
5. Tap on .
Configuring and Operating Function Key for Call Forwarding for Subscribers
Press the key to enable, disable and switch call forwarding for subscribers over.
Exception: A key that is defined to disable call forwarding for subscribers only disables the
currently enabled call forwarding for subscribers.
In addition, when functions are defined on the first key level, the status of the function is
indicated by the corresponding LED.
The configuration can be carried out as follows:
• Using COMfortel Set
• Using the telephone
switch on: Enables call forwarding for subscribers.
switch off: Disables call forwarding for subscribers. (No other action is
required.)
Up to 24 digits
Digits and the characters * and #
LED signalling on the key (not applicable if defined with "deactivate all"):
Red Call forwarding for subscribers is enabled for the configured destination.
Yellow Call forwarding for subscribers is enabled for another destination.
Off Call forwarding for subscribers is disabled.