Technical data

COMfortel 1400 - Firmware Version 1.4 - COMfortel Set V3.6 - Operation and Configuration V01 04/2014 307

Functions

Door Functions

Configuring and Operating Function Key for Door Functions

Important: Not available for operation on the PBX COMpact 3000 analogue/

ISDN/VoIP.

Press the key for general functions while the telephone is in the idle state to open the door

function menu. After this, you can initiate a door function for the configured door.

Press the key defined to initiate a call connection with the door (after picking up the receiver)

or to switch on the door opener and/or light.

In addition, when functions are defined on the first key level, the status of the function is

indicated by the corresponding LED.

The configuration can be carried out as follows:

• Using COMfortel Set

• Using the telephone

Using COMfortel Set to Configure the Function Key for Door Terminal Functions

Requirements:

– The authority level assigned in the PBX for the door terminal

– The relays configured in the PBX for the intercom, opening the door and the stairwell light

1. Open the page Function keys > Assign function keys.

2. Click one of the following tabs:

3. Right-click the function key you want to assign.

LED signalling on the key (only for defined key assignment):

Green The door opener function is enabled.

The door opener function is enabled and the light is switched on (only when

both functions are configured on the key).

Red A call connection has been established with the door.

Yellow The light is switched on.

Off None of the functions configured on the key are enabled.

Level 1: Keys are defined on the first key level.

Level 2: Keys are defined on the second key level.