User's Manual

Appendix J: All-In-One Computer User Manual

TM-5010-24P/24F User’s manual

Cleaning/Disinfecting



Steps:

1. Wipe the TM-5010-24P/24F with a dry clean cloth.

2. Operate with manufacturer’s instructions or hospital protocol.



Cautions:

 Do not immerse or rinse the TM-5010-24P/24F and its

peripherals. If you accidentally spill liquid on the device,

disconnect the unit from the power source. Contact your

Biomed regarding the continued safety of the unit before

placing it back in operation.

 Do not spray cleaning agent on the chassis.

 Do not use disinfectants that contain phenol.

 Do not autoclave or clean the TM-5010-24P/24F or its

peripherals with strong aromatic, chlorinated, ketone, ether,

or Esther solvents, sharp tools or abrasives. Never immerse

electrical connectors in water or other liquids.

Getting Started

System Set Up

The following is a summary of the steps in setting up the system

for use.

(1). You can fix the system to a mounting fixture using the screw

holes on the sides of the system.

(2). Make any required external connections such as the display,

keyboard, and LAN.

(3). Plug the appropriate end of the power cord into the power

connector on the rear of the system and the plug to an

electrical outlet.

(4). Waiting for 3 seconds then press the power switch on the

front panel of the system once to turn on the system power.

(5). If necessary, run the BIOS SETUP programs to configure the

system.

I-25