User's Manual

7. Spine Surgery with the XVISION-SPINE
System
When all preprocess tasks have been completed continue with preparing the surgical
procedure at the computer where the XVS SOFTWARE is installed.
7.1. New Study
Use the New Study screen to finalize all procedures for the surgical procedure.
Typically, at the end of the intraoperative scan, 3D data is sent directly to the computer where
the XVS SOFTWARE is installed. Whenever a network connection between the scanner and XVS
SOFTWARE is not available, data can be loaded via a portable USB drive.
See Configuring the Scanner Imaging Protocol on page5-6 for more information.
Note: Old data is never saved.
The intraoperative scan that is waiting in the queue, or that you have selected from a portable
USB drive, begins to load. The progress can be seen in the number of slices shown as
completed in the top right corner of the screen.
Figure 26: Confirm New Study
When the scan has been loaded confirm that this is the correct scan for the patient.
7-1