Installation Manual

Choose your adapter
Select your adapter from the Compatibility Chart above.
If your lock brand is not in the chart, slide each adapter onto the tailpiece to find the right one.
The correct adapter will have one of the teeth pointing up.
Attach the correct adapter
Place the correct adapter onto the tail piece. One of the triangle shaped teeth should be facing
up if you have the correct adapter. Make sure the non teeth side of the adapter goes in through
the tail piece first.
Rotate to unlocked position
Start by aligning the lock badge vertically to the logo, then rotate your smart lock’s outer shell to
the unlocked position (it may take moderate force). Determine the turn direction based on how
you turned the thumbturn to unlock the door.
Open the wing latches
Pull out both side wing latches to prepare for mounting on to the mounting plate.
Attach the smart lock
Slide the smart lock over the tailpiece and attach it to the mounting plate. The wing latches
should align to both the right and left side of the mounting plate and the lock should fit through
the adapter teeth.
To secure the smart lock, clamp down both side wing latches to the mounting plate completely.
Make sure the back of the lock is flush with the door, and the lock is able to lock and unlock the
deadbolt manually by rotating the outer shell.
Remove the faceplate
Press down on the August logo located at the bottom of the face plate. Grab the top of the
faceplate and remove it.
Remove the battery tab
While holding the batteries in place, remove the plastic battery isolation tab. Make sure that the
battery is properly seated in its compartment.