User Manual

Please fully charge the EP800 before first use or if left unused for a
long period of time.
To charge earphones, put earphones into the charging case. While
charging, two status LED lights red and turns off once fully charged.
To charge the charging case, use the power cable to connect the
charging case to a powered USB port.
The battery indicator flash one bar and turn to four bars once fully
charged. While charging, the battery indicator flash one bar and
turn to four bars once fully charged.
5.3Switch On / Off
5.3.1 Switch On / Off by charging case
To switch on the EP800, take out both 2 earphones from the charging
case. The EP800 will enter reconnection mode and the left status LED
will flash white.
To switch off the EP800, insert both 2 earphones back into the
charging case.
5.3.2 Switch On / Off by earphones (when earphones not in the
charging case)
To switch on the EP800, press and hold Power Button for 1 second. The
EP800 will enter reconnection mode and the left status LED will flash
white.
To switch off the EP800, press and hold Power Button for 5 second.
5.4Bluetooth Connections
The EP800 will enter reconnection mode after switching on and will
connect to any previous known device automatically. For first
connection, please refer 5.1 First use. To pair to a new device, insert
earphones back into the charging case, then disconnect the EP800
from your old device. Take earphones from the charging case again.
The left status LED will flash white for around 30 seconds at first,
and the left status LED will flash white and red alternately which
indicate EP800 enter pairing mode.
- For mobile phones and tablets
1. Scan for available Bluetooth device on your mobile phone or tablets.
(Please consult your device’s user manual if necessary)
2. Select ‘EP800.L’ from the available devices and confirm the
connection.
3. Once successfully connected, the status LED will turn off.
- For computers
1. Enable the Bluetooth function on your computer.
2. Select ‘Device and Printers’ from the Control Panel and click
‘Add a Device’.
3. Select ‘EP800.L’ from the available devices, the system will
automatically install the driver automatically. If a pin code is
requested, please enter the code ‘0000’.
4. Once successfully paired and connected, the status LED will
turn off.
5.5Resetting
Please try the following steps if fail to connect with the mobile device