Use Instructions

paper of the ECG electrodes. Attach the ECG electrodes onto the positions indicated by the
ECG/PPG Position Guide.
Then, place the PPG probe per the ECG/PPG Position Guide. Remove the ECG/PPG Position
Guide and secure the PPG probe with the adhesive tape.
Step 5: Power-on Combo Sensor Module.
Locate and press the Power On/Off Button. Look for a green light illuminating to confirm the
device is powered on.
Step 6: Set up the GA1000 Series or GA2000 Series.
Step 7: Connect Combo Sensor Module to the system.
Wait for the wireless connection of the system to be established. Once connected, the vital
signs of the Combo Sensor Module status information will appear on the MAIN screen.
NOTE: Refer to the GA1000 Series Instructions for Use (7MN00026-02) or GA2000 Series
Instructions for Use (7MN00022-02) for setting up instructions and verifying system
operation.
NOTE: Refer to “Device Pairing” section below for more information.
NOTE: The Power LED on the Sensor Box will blink green when pairing succeeds, and
data transmission starts.