Use Instructions

Troubleshooting
For additional troubleshooting, refer to the GA1000 Series Instructions for Use (7MN00026-02)
or GA2000 Series Instructions for Use (7MN00022-02).
If these solutions do not correct the problem, please contact your distributor, or contact Aulisa
by going online at www.aulisa.com under "Contact Us".
Problem
Possible Solution
Cannot power on the Combo
Sensor Module
1. Recharge the battery.
2. Press the Power button again.
Unusual vital sign data
1. Recheck device's location or contact with
the skin.
2. Ensure Sensor Cable is connected firmly to
the Sensor Box.
3. Reduce patient motion.
4. Check the Sensor Cable for any visible signs
of deterioration.
5. Use this device under instructed operation
conditions.
Cannot establish
system connection
1. Make sure the Combo Sensor Module is
within 32.8 feet (10 meters) spherical
radius to the Display Unit (for GA1000
Series), or to the Receiver/Transponder (for
GA2000 Series).
2. Power off the system and retry.
CAUTION!!! This system is a precision electronic instrument and must be repaired by
knowledgeable and specially trained Aulisa personnel only. Do not attempt to open the
case other than the battery cover or repair the electronics.