Operation Manual

Numerical function buttons:
1/
When completed searching radio stations automatically, press this button to listen to available stations, press and
hold the same button to save such stations manually; In the MP3 mode, press this button to pause playback, and press
the same button again to resume.
2/INT
When completed searching radio stations automatically, press this button to listen to available stations, press and
hold the same button to save such stations manually; In the MP3 mode, press this button to browse tracks, and press
the same button again to quit.
3/RPT
When completed searching radio stations automatically, press this button to listen to available stations, press and hold
the same button to save such stations manually; In the MP3 mode, press this button to enable the function of Single Re-
peat, and press the same button again to disable such function.
4/RDM
When completed searching radio stations automatically, press this button to listen to available stations, press and
hold the same button to save such stations manually; In the MP3 mode, press this button to enable the function of
Shule, and meanwhile, you can use buttons like and to select tracks randomly. Press the same button again
to disable such function.
5/-10
When completed searching radio stations automatically, press this button to listen to available stations, press and
hold the same button to save such stations manually; In the MP3 mode, press this button to play back the rst 10 tracks.
6/+10
When completed searching radio stations automatically, press this button to listen to available stations, press and hold
the same button to save such stations manually; In the MP3 mode, press this button to play back tracks more than 10.
Installation and Dismantling
Installation Diagram
Before installing the main part, place it according to the installation locations and then connect with the corresponding
speakers and power-supply; Do not x the main part unless it performs well.
Install the main part.
Place the holder on the dashboard and then bend certain snapping components by force; Connect with the power-
supply cable and speaker wires and then attach the xing tag to the auto-
mobile; Slide the main part into the holder and then tighten the nuts on the
xing tag.
Dismantle the main part
Following loosening those nuts on the xing tag,
insert each dismantling key into the space on either
left or right to pull the main part out. Later on,
detach the power-supply cable and speaker wires
and then the antenna connector.
http://www.auna-multimedia.com
multimedia
15