User Manual
FCCStatement
ThisequipmenthasbeentestedandfoundtocomplywiththelimitsforaClassBdigitaldevice,
pursuant to part 15 of FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates and can
radiateradiofrequencyenergy
and,ifnotinstalledandusedinaccordancewiththeinstructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interferencetoradioortelevisionreception,whichcanbedeterminedbyturning
theequipment
offandon,theuserisencouragedtotrytocorrect
Theinterferencebyoneormoreofthefollowingmeasures:
Reorientorrelocatethereceivingantenna.
Increasetheseparationbetweentheequipmentandreceiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is
connected.
Consultthedealeroranexperiencedradio/TVtechnicianforhelp.
ThisdevicecomplieswithPart15ofFCCRules.
Operationissubjecttothefollowingtwoconditions:
This device may not cause harmful interference, and this device must accept any interference
received,includinginterferencethatmay
causeundesiredoperation.
Note: The manufacturer is not responsible for any radio or TV interference caused by
unauthorizedmodificationstothisequipment.Suchmodificationscouldvoidtheuser’sauthority
tooperatethisequipment.
WhenonlyuseMIDbyportablemeetFCCRFExposureInformation(FCCSAR)
TheDevicemeetsthegovernment’s
requirementsforexposuretoradiowaves.
ThedeviceIdesignedandmanufacturednottoexceedtheemissionlimitsforexposuretoradio
frequency(RF)energysetbytheFederalCommunicationCommissionoftheU.S.Government.
Theexposurestandardforwirelessmobiledevicesemploysaunitofmeasurementknowsasthe
Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6W/Kg. Tests for SAR are
conductedusingstandard operatingpositions acceptedbythe FCC with the devicetransmitting
at its highest certificated power level in all tested frequency bands. Although the SAR is
determined at the highest certificated
power level, the actual SAR level of the device while
operating can be well below the maximum value. This is because the device is designed to
operate at multiple power levels so as to use only the poser required to reach the network. In
general,thecloseryouareto
awirelessbasestationantenna,thelowerthepoweroutput.
ThehighestSAR valueforthedeviceasreported totheFCCwhentestedforusewhenwornon
thebody,asdescribedinthisuserguideis0.885W/KgforBodyandsummationis0.885W/Kgfor
Body.
While there may be
difference between the SARvalues levelsof various devices and at various
positions,theyallmeetthegovernmentrequirement.
Talpad’salsomeetFCCRFRadiationExposureStatementwhenenduserusetogetherwithMID.
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled
environment. This
equipment should be installed and operated with a minimum distanceof 20
centimetersbetweentheradiatorandyourbody.