LMS-335 Studio Monitor Stands (Set of two) Owner’s Manual
Introduction Thank you for choosing Auray LMS-335 Studio Monitor Stands. These sturdy monitor stands are an ideal solution for professional and home recording studios. Each stand has a top monitor mounting plate measuring 9" square and is capable of supporting monitors up to 90 lb. The sturdy, wide-base, three-leg design with rubber feet and included spikes ensure stability on all types of floor surfaces. Each stand can be adjusted to six different heights.
Overview Monitor mounting plate 1 1 Telescoping shaft 2 2 Locking knob 3 3 Locking pin 4 4 Lag attachment plate cover 5 Top lag attachment plate 6 Bottom lag attachment plate 7 Legs 8 LMS-335 5 6 7 8 Rubber feet 9 9 Spikes 10 10 Washers & nuts 11 11 Touch-fastener straps 12 12 Open-end wrench 13 13 Allen wrench 14 14 Socket screw 15 15 Carriage bolts 16 16 Locknuts 17 17 Owner’s Manual 3
Assembly Instructions Attaching the legs 1. Position the shaft horizontally. 2. Slide the lag attachment plate cover and top lag attachment plate away from the bottom lag attachment plate. 1 1 3. 4. 5. With the open side of the rubber foot facing down, position the first leg against the shaft. Align the holes of the bottom lag attachment plate and the leg. Slide the top lag attachment plate into position above the leg so that all the holes are aligned.
7. If using the stand on a carpeted area, remove the rubber feet, insert the flat end of the spikes up through the bottom of the legs, and secure them with the washers and nuts on the top of the leg. 5 8. Slide the lag attachment plate cover down to cover the bolt heads, and place the stand into the upright position. 6 Attaching the Monitor Mounting Plate 1. Align the monitor mounting plate on top of the shaft with the indented hole fitting into the top of the shaft, and insert the socket screw. 1 2.
Operating Instructions Important: Make all height and location adjustments before mounting your monitors onto the stands. Adjusting the height 1. Loosen the locking knob. 2. Raise or lower the telescoping shaft to the desired height and insert the locking pin completely through the holes on both sides of the shaft. 1 3. Lower the shaft until it rests on the locking pin. Tighten the locking knob. 2 1 2 Mounting the monitors 1.
Recommended accessories • Auray IP-S Isolation Pad • Auray IPRS-S Recoil Stabilizer Specifications Minimum height: 35" (88.9 cm) Maximum height: 58.5" (148.6 cm) Load capacity: 90 lb. (40.8 kg) Plate size: 9" × 9" (22.9 × 22.9 cm) Weight: 10.35 lb. (4.69 kg) Base spread: 23" (58.
One-Year Limited Warranty This AURAY product is warranted to the original purchaser to be free from defects in materials and workmanship under normal consumer use for a period of one (1) year from the original purchase date or thirty (30) days after replacement, whichever occurs later.