User's Manual
Chapter 2 Getting Started
TMC7200 SERIES USER MANUAL
Page: 2-14
Safety Precautions
Before operating this system, read the following information carefully to protect
your systems from damages, and extend the life cycle of the system.
1. Check the Line Voltage
• The operating voltage for the power supply should be within the range
of 100V to 240V AC; otherwise the system may be damaged.
2. Environmental Conditions
• Place your TMC7200 on a sturdy, level surface. Be sure to allow
enough space around the system to have easy access needs.
• Avoid installing your TMC7200 system in extremely hot or cold
places.
• Avoid direct sunlight exposure for a long period of time (for example,
in a closed car in summer time. Also avoid the system from any
heating device.). Or do not use TMC7200 when it has been left
outdoors in a cold winter day.
• Avoid moving the system rapidly from a hot place to a cold place, and
vice versa, because condensation may occur inside the system.
• Protect your TMC7200 from strong vibrations which may cause hard
disk failure.
• Do not place the system too close to any radio-active device.
Radio-active device may cause signal interference.
• Always shut down the operating system before turning off the power.
3. Handling
• Avoid placing heavy objects on the top of the system.
• Do not turn the system upside down. This may cause the hard drive
to malfunction.
• Do not allow any objects to fall into this device.
• If water or other liquid spills into the device, unplug the power cord
immediately. cradle
4. Good Care/Maintenance
• When the outside case gets stained, remove the stains using neutral
washing agent with a dry cloth.
• Never use strong agents such as benzene and thinner to clean the
surface of the case.
• If heavy stains are present, moisten a cloth with diluted neutral
washing agent or alcohol and then wipe thoroughly with a dry cloth.
•
If dust is accumulated on the case surface, remove it by using a
special vacuum cleaner for computers.