Installation Guide

Wrench

Basin

Bucket

Small

Wrench

Adjustable

Sealant

Thread

Tape

Plumbers

TOOLS AND MATERIALS:

supply have been completed.

necessary repairs or modiﬁcations to the water

faucet has been completely removed and any

For these instructions, it is assumed that the old

materials that are needed for the installation.

Ensure that you have gathered all the required

team at 1-866-855-2284.

BEFORE YOU BEGIN

GETTING STARTED

Kitchen Faucet Installation Instructions

any damage is found, contact our Customer

We recommend consulting a professional if you are

unfamiliar with installing plumbing ﬁxtures. We accept

no liability for any damage to the

faucet, plumbing, sink, counter top, or for personal injury

during installation.

Observe all local plumbing and building codes.

Unpack and inspect the faucet for shipping damage. If

vice

KITCHEN FAUCET INSTALLATION

PAGE 1
KITCHEN FAUCET INSTALLATION BEFORE YOU BEGIN We recommend consulting a professional if you are unfamiliar with installing plumbing ﬁxtures. We accept no liability for any damage to the faucet, plumbing, sink, counter top, or for personal injury during installation. TOOLS AND MATERIALS: Plumbers Tape Small Bucket Thread Sealant Observe all local plumbing and building codes. Unpack and inspect the faucet for shipping damage. If any damage is found, contact our Customer service. team at 1-866-855-2284.
PAGE 2
KITCHEN FAUCET INSTALLATION INSTALLATION 1. Ensure that the water supply below your sink is completely shut oﬀ by turning the shutoﬀ valves all the way to the right. Tip: Place a small bucket below your workspace to catch any water that may drip during the installation process. 3. From beneath the sink, slide the rubber gasket back onto the faucet body followed by the metal washer. Thread the locknut back onto the faucet body, and tigheten using a basin wrench.
PAGE 3
KITCHEN FAUCET INSTALLATION 5. Once installation is complete, turn the main water supply back on from underneath your sink. Check for any leaks underneath. 6. Remove the hand sprayer by unthreading it from the sprayer hose. Turn the faucet on for approximately 60 seconds to remove any dust or loose sediment from the water lines, and to ensure that there are no leaks. Check to ensure that both hot and cold water are running properly. Reattach the sprayer and turn it on.