Installation Guide

Apply Thread Sealant
Water Lines
Position Handle
OFF
Rubber Gasket
Lock Nut
Metal Washer
Remove
connecting the hot and cold lines appropriately.
threads before tightening. Ensure that you are
lines. Apply thread sealant or plumber’s tape to the
4. Attach the main water lines to the faucet’s water
before the rubber gasket.
plastic support. The support should slide on first,
For thin mounting surfaces, use the provided Note:
tigheten using a basin wrench.
Thread the locknut back onto the faucet body, and
onto the faucet body followed by the metal washer.
3. From beneath the sink, slide the rubber gasket back
process.
catch any water that may drip during the installation
Place a small bucket below your workspace to Tip:
way to the right.
completely shut off by turning the shutoff valves all the
1. Ensure that the water supply below your sink is
the faucet so that the handle is on the right, as shown.
through the mounting hole in your counter top. Position
gasket from the faucet body. Insert the faucet body
2. Remove the lock nut, metal washer, and rubber
INSTALLATION
Kitchen Faucet Installation Instructions
2
KITCHEN FAUCET INSTALLATION