User manual

~ 7 ~
1. Connect a HDMI or DVI source (such as a Blu-ray Disc player) to the transmitting unit
ASP-CATX1RS-TX.
2. Connect a HDMI or DVI display (such as a LCD TV) to the receiving unit ASP-CATX1RS-RX.
3. Connect IR Blaster/Receiver to both TX and RX units and or RS-232 connections.
4. Connect a Cat-5/5e/6 cable between the transmitting and receiving units.
5. Make sure this Cat-5/5e/6 cable is tightly connected and not loose.
6. Plug in 5V DC power supply unit to the power jack of the receiving unit ASP-CATX1RS-RX.
7. Plug in 5V DC power supply unit to the power jack of the transmitting unit ASP-CATX1RS-TX.
8. If you see flickering or blinking image on the display, please adjust the rotary control switch to
improve the cable skew. 0 stands for the strongest HDMI signal level for longest possible
transmission length while 7 stands for the weakest HDMI signal level for short transmission
length. Please adjust the signal level from 7 to 0 and stop turning the rotary switch whenever
the audio/video is playing normally. Inappropriate signal level setting may cause overpowering
issue that would shorten the product life significantly!
Hardware Installation