Installation manual

D-TUNE Installation Manual
11
Default Chan -- Specifies the default channel, which will be selected upon D-TUNE power-up. If
this default channel is set to “0” -- the default channel will be the last channel
selected before the D-TUNE was powered off.
Rename Current Channel
-- Change the text label assigned to the current channel. This label is shown (if
enabled) on screen, along with the channel number, when the D-TUNE is
switched to this channel. Display of labels and channel numbers can be globally
disabled on enabled, see the subsequent menu options.
Show Label -- Setting to enable will show up to an 8 character label specific to the channel
when changing channels.
Show Number -- Setting to enable will show up the channel number when changing channels.
Mode -- Select tuner mode (channels allocation) to use, among broadcast and several
cable options.
Tune Channels -- Scans the channels, looking for valid signal presence, and “remembers” which
channels are valid and which are not. This “validity mask” is used then for
channel browsing using channel +/- buttons (so that a user browses through the
defined channels only). Note that before this operation D-TUNE must be
connected to RF-antenna or cable TV.