Installation manual

D-TUNE Installation Manual
20
10 Specifications
10.1 Power source
12v 15 Watt DC wall supply
5.65 Watts Maximum with 12v DC input
10.2 Applicable signals
Color system: NTSC (RF and AV inputs)
Scanning format: 525i (480i), 525p (480p)
RF Tuner (North America)
Input Connector : 'F' type female
Receiving RF signals – US Standard Air, US Standard Cable, Cable HRC, Cable IRC
TV Frequency Range : 55.25 to 801.25 MHz, 31.25 or 62.5KHz fine tune
FM Frequency Range : 76.00 to 108.00 MHz, 50KHz fine tune
Demodulation: Quasi-Split Sound concept
Color system: PAL/SECAM (RF and AV inputs)
Scanning format: 576i, 576p
RF Tuner (International)
Input Connector : 'IEC' type female
TV Frequency Range : 48.25 to 855.25 MHz, 31.25/50.0, or 62.5KHz fine tune
FM Frequency Range : 76.00 to 108.00 MHz, 50KHz fine tune
Video Input
Connector: RCA female Yellow
Input: Composite video
Impedance: 75 ohms
Typical Level: 1.0V peak-peak into 75 ohms
Supported audio standards: auto-detection, BTSC-STEREO, BTSC-MONO+SAP, NICAM
Serial port – RS-232C compatible, can be used for Plasma Display control, firmware update, and D-
TUNE control/diagnostics. Baud rate –9600, 8 bits data, 1 start bit, 1stop bit, no parity bit.
10.3 Connection terminals
Video IN (RCA)
S-Video IN (Mini DIN 4pin)
Component YPbPr/RGB+HV IN – 15-pin female VGA-compatible connector.
Audio stereo IN/OUT – 8 pin mini DIN. Requires adapter cable with 4 pairs of RCA connectors.
TV (aerial) IN – RF UHF/VHF
FM (aerial) IN – RF
Component YPbPr/RGB+HV OUTPUT – 15-pin female VGA-compatible connector.
IR IN – 3.5mm TRS (Tip – Signal, Ring – 12v (if jumped internally), Sleeve – Ground)
IR OUT – 3.5mm TRS (Tip – Signal, Ring – NA, Sleeve – Ground)
RS-232 – DB9 Connector (2- RX, 3- TX, 5- Ground)