User's Guide

MLink Ultra User’s Guide Page 6 4/1/2021 1:39 PM
106, 4715 - 13th St. NE, Calgary, Alberta, Canada, T2E 6M3
[phone] [e-mail]
Confidential and Proprietary
Figure 8.1.1.1 – FCC Label
8.1.2 FCC Notices
WARNING: The MLink Ultra modules have been tested by the FCC for use with other products
without further certification (as per FCC Section 2.1091). Changes or modifications to this device
not expressly approved by Aurora Wireless Networks Inc could void the user’s authority to
operate the equipment.
NOTICE: OEM’s must verify the final end product complies with unintentional radiators (FCC
Section 15.107 and 15.109) before providing a declaration of conformity for their final product to
Part 15 of the FCC Rules.
NOTICE: The MLink Ultra modules have been certified for mobile and fixed radio applications. If
the module will be used for portable applications, the device must undergo SAR testing.
RF Exposure WARNING: This equipment complies with FCC radiation exposure limits set forth
for an uncontrolled environment. This equipment should be installed and operated with minimum
distance 20 cm between the radiator and your body. This transmitter must not be co-located or
operating in conjunction with any other antenna or transmitter.
NOTICE: The preceding statement must be included as a CAUTION statement in OEM product
manuals in order to alert users of FCC RF Exposure compliance.
8.2 Canada (IC)
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject
to the following two conditions: (1) this device may not cause interference, and (2) this device
must accept any interference, including interference that may cause undesired operation of the
device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation est autorisée aux deux
conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2)
l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même
si le brouillage est susceptible d'en compromettre le fonctionnement.
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a
type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce
potential radio interference to other users, the antenna type and its gain should be so chosen that
the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful
communication.
Conformément à la réglementation d'Industrie Canada, le présent émetteur radio
peut fonctionner avec une antenne d'un type et d'un gain maximal (ou inférieur)
approuvé pour l'émetteur par Industrie Canada. Dans le but de réduire les
risques de brouillage radioélectrique à l'intention des autres utilisateurs, il faut
choisir le type d'antenne et son gain de sorte que la puissance isotrope rayonnée
équivalente (p.i.r.e.) ne dépasse pas l'intensité nécessaire à l'établissement
d'une communication satisfaisante.
This radio transmitter Model: AMU900, IC: 27118–AMU900 has been approved by Industry
Canada to operate with the antenna types listed below with the maximum permissible gain and
required antenna impedance for each antenna type indicated. Antenna types not included in this