User Guide

Assembly Instructions
1
IMPORTANT! Please read before use.
2
4
NOT CORRECT
PUSH
DOWN
PUSH
DOWN
SHAPE ON BACK OF HEAD MATCHES
www.auroracorp.com
Customer Service: 1-800-327-8508
CORRECT FIT
Using the handle on the shredder head, lift and gently place head onto
the rim of the shredder body. Make certain the clips on the edge of the
body are inline with the openings underneath the shredder head. The
curved flap-like shape located on the back of the shredder head should
also align and fit properly as shown.
Complete assembly by sliding the wastebasket back in. Plug shredder
into a nearby socket-outlet and switch the power mode over to “Auto”.
A green power indicator will signal when ready for use.
When aligned, apply pressure and gently push the shredder head
down to attach onto the shredder body. When correctly mounted, the
shredder head will sit flush as pictured. There should be no space
between the shredder head and body.
3
Carefully lift and remove the shredder head from the wastebasket.
WASTEBASKET MUST BE SLID OUT FOR ASSEMBLY.
Caution: Shredder should not be plugged in during assembly. Crosscut
shredders have very sharp exposed blades on the underside. Use care
when handling.