User guide

8
User Guide
EDID SETUP
Dip Switch
SW1-SW8 for EDID & audio/video settings
DIP Switch Position
Video Audio Description
Pin 1 Pin 2
OFF [] OFF [] Up to 1080p
Surround
1
Default Mode
2
– Up to 1080p & surround sound
audio output up to 7.1ch (DTS-HD Master & Dolby
TrueHD)
OFF [] ON [] Up to 1080p Stereo
Safe Mode
3
– Make the system output at 1080p
video and stereo audio for basic compatibility
among HDTVs
ON [] OFF []
Bypass
4
Bypass
4
EDID Learning Mode
5
– for learning EDID from
the display while playing any received HDMI audio
format
ON [] ON [] Bypass Stereo
EDID Learning & Stereo Mode
5
– for learning
EDID from the display while enforcing stereo
output if any HDTV cannot play surround sound
normally
Note
1
If the HDTV shows video but without audio, please try to set audio mode to stereo.
2
Factory default setting of [SW1]-[SW8] is pin 1 at OFF [] & pin 2 at OFF [] for 1080p and
surround sound audio.
3
If you encounter any unsolved audio/video output problem during system installation, please
turn any [SW1]-[SW8] to pin 1 at OFF [] & pin 2 at ON [] for safe mode to enforce the
most compatible 1080p stereo output for system check. However, the safe mode cannot be
initiated if your HDMI source is set to enforce 1080p output. In this case, please reconfigure
your HDMI source to all resolution output for troubleshooting.
4
Bypass means the matrix will maintain playing the original format of HDMI signals in video
and perhaps audio. By setting at this mode, the users may encounter compatibility issue
among different kinds of HDMI sources and displays. If you cannot get the audio and/or video
output normally at the system installation, please change the DIP switch setting to default
mode or even safe mode to verify the functionality of the device.
5
To learn the EDID of the HDMI display for respective HDMI source devices, please see the
[EDID Learning] section for more detail information.